Dormont® SuprSafe® 0240185

Tubing Annealed, 304 stainless steel (ASTM A240) Brass or plated steel flare nuts and adapters Optional coating heavy-duty, antimicrobial, hot-dipped gray PVC (41, 51 and 61 series) Coating will not hold a flame Approved for indoor/outdoor use with stationary gas appliances/equipment -40 to 150 deg F operating temperature with adapters 100% leak tested Exclusive No-Neck® design increases flexibility More corrugations per inch increase flexibility and extend service life When installing a new appliance or when an existing appliance is moved to a new location a NEW gas connector must be per manufacturer's installation instructions and product standards Eliminates the need for pipe nipples, 90's and elbows Pre-fabricated gas connector means no field threading, cutting or assembly of CSST fitting and tubing Available with hot-dipped PVC coating with antimicrobial agent, SafetyShield yellow coating (40C Series), or Stainless Steel 465440 btu/cu-ft for LP gas BTU/hr1.55 SG, 2500 BTU/cu-ft at 0.5 in water column pressure drop straight length capacity for LP gas Designed for occasional movement after installation City of New York MEA No 376-92-M Approved by the Commonwealth of Massachusetts Board of State Examiners of Plumbers and Gas Fitters - connector length may not exceed 48 in BTU/hr 0.64 SG, 1000 BTU/cu-ft at 0.5 in water column pressure drop straight length capacity for natural gas Boilers, gas meters, furnaces, commercial water heaters, gas packs/rooftop HVAC units, tankless water heater, stationary standby generators